Oh Noes! The Clutch Is Gone... And Back

...now have to figure out what's the cause, and how it is related to yesterday's brake bleeding session.

Master cylinder is the main suspect until the morning sun comes.

UPDATE: Just air in the system, nothing more. Bled the hell out of it while identifying the issue - it's not immediately obvious where the intake hose is, and it's easy to suck the air into the clutch system unless you're watching the fluid level in the main reservoir. For the reference, a safe volume from the maximum level to the level you have to stop at is about 8 fl oz, or 200ml.

Before you set out to bleed the clutch, you may want to check if you need to replace the bleeder screw (part #21521116360), and whether the dust cap (part #21521102908) is in place - will save you some grief.

It is possible to use a vacuum bleeder to bleed the clutch, even though this is not a recommended way - you will most probably have to unscrew the bleeder screw completely (there will not be a massive leak), wrap it into teflon tape and screw it back (thanks to mooseheadm5 for the advice) - otherwise you'll be sucking air through the bleeder screw thread.

While you're there, you might just as well take off the slave cylinder and push the air out of it. Don't have the pedal all the way up when you're installing the slave cylinder back, you won't be able to overcome the resistance of the clutch release spring and put the nuts back.